| picture |
|
Details
|
|
| The IS 150W-24DR is a fully regulated output voltage power supply. The output voltage is normally preset at the factory. Please consult Customer Services for your voltage requirements when ordering. | |
| Note: | Installed On Din Rail TS35/7.5 or 15 |
|
Stock Code
|
Description
|
DC Output Voltage
|
Output Current
|
Efficiency
|
|
897.084.17
|
IS 150W-24DR
|
24V
|
6.3A
|
85%
|
| Specifications | |
| AC Input Voltage Range | 85~132VAC/170~264VAC Selected By Jumper |
| Input Frequency | 47~63Hz |
| Inrush Current | Cold Start, 40A/230V |
| Input Leakage Current | <0.7mA/230VAC |
| Load Regulation | <0.5% |
| Line Regulation (Full load) | < ±0.5% |
| Output Voltage Adjustable Range | ±10% |
| Output Over Voltage Protection | 115~150% |
| Output Over Current Protection | 110~130%, Delay Shutdown |
| Withstand Voltage | I/P-O/P: 3.0KVAC/1min |
| I/P-F/G: 1.5KVAC/1min | |
| O/P-F/G: 0.5KVAC/1min | |
| Rise, Hold Up Time | 50ms, 20ms @ Full Load (Tipical) |
| Operating Temperature & Humidity | -10ºC~+50ºC, 20~93%RH (Non Condensing) |
| Safety Standards | UL508, UL60950Approved , EN60950 |
| EMC Standards | EN55022 Class B, EN55024, EN61000-3-2,3 |
| EN61000-4-2,3,4,5,6,8,11 | |
| Cooling Method | Convection |
| Dimensions | 108.4x83.6x109(mm) |
| Weight | 1.0kg |
|
The power supply is factory preset at the customer specified output voltage.
|
|
|
|
Installation
|
|
The power supply should be installed in a well ventilated area and not enclosed where excessive heat build up can occur. Do not install or mount above any hot air discharge/air-conditioner/radiator or similar equipment. Mounting outside or in a wet/damp environment is also not recommended. Keep fan intake/output vents well clear of any material likely to block them.
|
|
Batteries
|
|
The above power supplies are not suitable for charging the battery.
|